Grimrock

Hi! Just wondering if the GeForce 320M is supported, or if I could run LoG on low settings? I have more than the minimun RAM in my Mac. Thank you either way!

The low rendering on Windows requires OpenGL 2.1 support.

viewtopic.php?p=52192#p52192

You can see if your card support it by searching or executing a program made for that.

Thanks for responding, but... I couldn't find the test that you mentioned in your link. Although, I did find that I at least have the Open GL requirement.

The other thing I was wondering is if my below minimum VRAM amount will cause a crash.

Issac wrote:Thanks for responding, but... I couldn't find the test that you mentioned in your link. Although, I did find that I at least have the Open GL requirement.

The other thing I was wondering is if my below minimum VRAM amount will cause a crash.

by architecture it's no problem ( dirextX 10.1, opengl 3.3)
http://en.wikipedia.org/wiki/Comparison ... .29_series

Also, was confirmed from petri himself in low spec mode 45-60fps
(viewtopic.php?f=12&t=3999&hilit=320m#p44048)

even 256 mb graphiccards run fine (viewtopic.php?f=12&t=2358&p=24832&hilit=256mb#p24832)

@ Badhabit - Thank you!

ßeta patch 1.3.7 addresses the OpenGL 2.1 needed for rendering in low-quality mode.